This application note contains details on digitizer OS support.

This document describes an application intended for testing the transfer link between the host PC and the digitizer with respect to achievable and sustainable performance.

This application note gives an introduction to high performance digitizer theory including the critical parameters: signal power, noise level and reflections (impedance mismatch).

The firmware option FWPD, for the ADQ14 and ADQ7, is tailored to detected and analyze pulses in demanding measurement applications where the properties of the pulses are not known in advance.

The firmware option FWATD (advanced time domain) for ADQ7 and ADQ14 is designed for extreme dynamic range.

The data processing is as important as the acquisition, and this application note describes ways of processing the large amount of data that the ADQ-series of digitizers produce.

This document contains a description of the firmware option ADQ7-FW2DDC for the digitizer hardware platforms ADQ7DC and ADQ7WB.

This application note describes how to stream data to disk in a high speed recording system. The measured performance is 1.5 GBytes/s sustained to disk.

This application note is a guide to how to set up the data transfer and combine it with on-board feature extraction (data reduction) to meet the requirements of the application.

This document contains a general description of the clock system and examples on how to use it.